Velleman HAMGSM133 Notice D'emploi page 8

Note: the caller ID of the used mobile phone must not be hidden (callers' phone number must be visible when
calling another mobile phone).
At the end of the hold mode the yellow LEDs are switched off and the device waits for a configuration SMS.
With the same phone used to make the first setup call, it is also possible to switch the relay status.
8.2 Through SMS
This mode takes full advantage of the device with operations as output switch, output status query, inclusion of
additional phone numbers to activate the relay, inclusion of numbers for door opening function, reception of
reply messages; change output signals timing and, in general, set the HAMGSM133 with all parameters via
simple SMS. A full reset to restore the default settings can also be made via SMS. See below for the syntax for
all available commands.
8.3 SMS syntax
• Commands and settings can be sent from any mobile phone as long as the message includes the
password.
• For some commands a password is not required when the message was sent from a telephone number
which is stored in the HAMGSM133. However, some commands that change critical information always
require a password.
• The HAMGSM133 replies with a confirmation or information SMS.
• Multiple commands can be combined in 1 SMS by placing a comma in between.
• Note: commands never contain spaces.
Refer to overview of all configuration SMS commands below.
Change password
Password
Command
Example
Store numbers
Password
Command
Example
Result
Remove numbers
Password
Command
Example
Result
List stored numbers
Password
Command
Example
Result
V. 02 – 15/05/2012
HAMGSM133
required
PWDxxxxx;pwd
xxxxx = new password (5 digits)
pwd = current password (default = 12345)
PWD54321;12345
required for overwrite or from unknown phone
NUMx+YYnnnnnnnnnn;pwd
YY = country code
x = position of the number in the list (1~8)
nnnnnnnnnn = phone number (max. 19 digits)
pwd = current password (default = 12345)
NUM7+324851234567;12345
Number +324851234567 is stored on location 7 in the master list.
Required
NUMx;pwd
x = position of the number in the list (1~8)
pwd = current password (default = 12345)
NUM5;12345
The number on location 5 is removed from the master list.
required
NUM?;pwd
pwd = current password (default = 12345)
NUM?;12345
Show the master list.
8 ©Velleman nv