Configuration - Velleman HAMGSM133 Notice D'emploi

5. Overview
Refer to the illustrations on page 2 of this manual.
1 power supply
2 USB interface (optional)*
O1 output 1
O2 output 2
LD1 relay 1 active
LD2 relay 2 active
LD3 input 1 active (logical condition reached)
LD4 input 2 active (logical condition reached)
LD5 GSM network connection status
U1 transmit LED
U2 receive LED
6. Installation
• When applicable install the USB interface HAMGSM133/USB [2] (not included). The mini USB connector
must be on top.
• Insert a valid SIM card [3]. Make sure the PIN code of the SIM card is disabled. Use a normal mobile
phone for this.
• Connect the antenna to the antenna connector [4].
• Make all necessary connections (I1, I2, O1, O2). Only connect a SELV (Safety Extra Low Voltage) load
to the outputs. Tension applied to the contacts of each relay must not exceed 60Vdc; switching current
on the relays must not exceed 10A (short peak). The maximum tension applied to the digital inputs is
32Vdc.
• Connect the power supply [1] (not included). Use a stabilized current-limited power supply (not
included) providing 9~32Vdc and at least 500mA current (able to deal with absorption peaks of 1A).
Note that the centre tip is positive.
• Close the housing (not included).
7. Introduction
• The HAMGSM133 is a bidirectional remote control module capable of remotely controlling two relays
(in monostable or bistable mode) through the use of special SMS commands sent from any mobile
phone.
• Memory for up to 8 telephone numbers to which SMS and/or ringtones can be sent when input status
changes (master list).
• It is also possible to use the HAMGSM133 as a gate control receiver controlled by up to 200 entered
phone numbers (gate control list).
• To facilitate programming, it is possible to connect a USB interface module and manage the device via
PC through downloadable software. This module must be purchased separately; order code
HAMGSM133/USB.
8.

Configuration

There are 3 ways to set up the device:
• through call (only at start-up)
• through SMS
• through USB (USB interface required, not included).
8.1 Through call (only at start-up)
When the device is supplied with power, "LD5" will immediately flash at 1 Hz frequency. The HAMGSM133 will
try to connect to the GSM network. When connected, "LD5" will briefly flash every 2 seconds. After the system
initialization (which may take several seconds), the device alternately illuminates yellow LEDs "LD3" and "LD4"
to indicate the "configuration call" on hold mode for 3 minutes. If during this time the unit receives a call, it
stores the caller's number (to which reply SMS will be sent) in the first memory location and LD3 and LD4 turn
off.
V. 02 – 15/05/2012
HAMGSM133
3 SIM card (not included)
4 antenna connector
I1 input 1
I2 input 2
U3 mini USB connector
7
* HAMGSM133/USB, not included
©Velleman nv