Velleman HAMGSM133 Notice D'emploi page 13

Request current setting of relay status backup
Password
Command
Example
Result
Start-up SMS content
Password
Command
Example
Result
Activate start-up SMS
Password
Command
Example
Result
Gate control activation (relay 1)
Password
Command
Example
Result
Store gate control phone numbers (max. 200)
Password
Command
Example
Delete gate control phone numbers
Password
Command
Example
Disable reply SMS
Password
Command
Example
V. 02 – 15/05/2012
HAMGSM133
RIP?
RIP?
Get an overview of the current setting for the output relay backup.
TSU:xxxxxxxx
xxxxxxxx = message (max. 100 characters, all capitals)
TSU: SYSTEM START-UP
When enabled (see AVVx command), this message is send to phone number
on the first position in the list. Default: SYSTEM STARTUP
Note: a semi colon (;) is not allowed inside the message
AVVx
x = 0 (disabled) or 1 (enabled)
AVV1
Enable sending an SMS to the phone number on the first position in the list
when the device is started or restarted. Default: 0 (disabled)
TAC:ss
ss = time in seconds (00~59)
TAC:12
When receiving a call from any of the 200 gate control numbers or 8
numbers in the master list, the relay will remain activated for 12 seconds.
Default: 3 seconds
Note: When setting the time to 00, the relay operates in bi-stable mode;
relay 1 will switch status every time the device receives a call.
required
MAC+YYnnnnnnnnnn;pwd
YY= country code
nnnnnnnnnn = phone number (max. 19 digits)
pwd = current password (default = 12345)
MAC+324851234567;12345
Note: There are no specific locations for gate control phone numbers.
required
DAC+YYnnnnnnnnnn;pwd
YY= country code
nnnnnnnnnn = phone number to delete
pwd = current password (default = 12345)
DAC+324851234567;12345
RISP (commands)
Commands: series of commands separated by commas (,)
RISP, OUT1:ON, DAC, INI1:10
13 ©Velleman nv