Parkside PWSAP 20-Li C3 Instructions D'utilisation Et Consignes De Sécurité page 47

5) Always use undamaged wheel
flanges that are of correct size and
shape for your selected wheel. Proper
wheel flanges support the wheel thus
reducing the possibility of wheel breakage.
Flanges for cut-off wheels may be different
from grinding wheel flanges.
6) Do not use worn down wheels from
larger power tools. Wheel intended for
larger power tool is not suitable for the higher
speed of a smaller tool and may burst.
Additional safety warnings specific for
abrasive cutting-off operations
1) Do not "jam" the cut-off wheel or
apply excessive pressure. Do not
attempt to make an excessive depth
of cut. Overstressing the wheel increases
the loading and susceptibility to twisting
or binding of the wheel in the cut and the
possibility of kickback or wheel breakage.
2) Do not position your body in line
with and behind the rotating
wheel. When the wheel, at the point of
operation, is moving away from your body,
the possible kickback may propel the spinning
wheel and the power tool directly at you.
46 GB/IE
3) When wheel is binding or when
interrupting a cut for any reason,
switch off the power tool and hold
the power tool motionless until the
wheel comes to a complete stop.
Never attempt to remove the cut-off
wheel from the cut while the wheel
is in motion otherwise kickback may
occur. Investigate and take corrective action
to eliminate the cause of wheel binding.
4) Do not restart the cutting operation
in the workpiece. Let the wheel
reach full speed and carefully re-
enter the cut. The wheel may bind, walk
up or kickback if the power tool is restarted in
the workpiece.
5) Support panels or any oversized
workpiece to minimize the risk of
wheel pinching and kickback. Large
workpieces tend to sag under their own
weight. Supports must be placed under the
workpiece near the line of cut and near the
edge of the workpiece on both sides of the
wheel.
6) Use extra caution when making a
"pocket cut" into existing walls or
other blind areas. The protruding wheel
may cut gas or water pipes, electrical wiring
or objects that can cause kickback.