Safety Instructions; Quick Specifications - Dell P992 Guide D'installation Rapide

Dell™ P992 Color Monitor
Quick Setup Guide

Safety Instructions

Observe the following safety guidelines when connecting and using your monitor:
• Be sure that your monitor is electrically rated to operate with the AC power available in your location.
• Locate your monitor near an easily accessible electrical outlet.
• Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply hit, or touched
with a sharp or abrasive implement.
• Put your monitor in a location with low humidity and a minimum of dust.
• Never use your monitor if the power cable has been damaged. Do not allow anything to rest on the power cable, and
keep the cable away from where people could trip over it.
• Never insert anything metallic into the monitor openings. Doing so may create the danger of electric shock.
• To avoid electric shock, never touch the inside of the monitor. Only a qualified technician should open the monitor's case.
• Be sure to hold the plug, not the cable, when disconnecting the monitor from an electrical outlet.
• Openings in the monitor cabinet are provided for ventilation. To prevent overheating, these openings should not be
blocked or covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface. Doing so may block the
ventilation openings in the bottom of the cabinet. If you put the monitor in a bookcase or some other enclosed space,
be sure to provide adequate ventilation.
• Do not expose the monitor to rain or use it near water. If the monitor accidentally gets wet, unplug it and contact an
authorized dealer immediately. You can clean the exterior of the monitor with a damp cloth when necessary, but be sure
to unplug the monitor first.
• If your monitor does not operate normally-in particular, if there are any unusual sounds or smells coming from it-unplug
the monitor immediately and contact an authorized dealer or service center.

Quick Specifications

AC input voltage/frequency
Current
Operating Temperature
Dimensions
Weight (monitor only)
Other accessory items in the package
Connecting Your Monitor to a Computer
1 Turn off your computer and unplug its power cable.
2 Connect the HD15 video signal cable to the video output of your computer.
3 Connect the power cable for your monitor to the power port on the back of the monitor.
4 Plug the power cable of your computer and your monitor into a nearby outlet.
5 Turn on your monitor and computer. If the monitor does not display an image, refer to the troubleshooting section of
this guide.
100 – 240 V ~ 50 – 60 Hz
2.0 A (RMS) at 120 VAC and 1.0 A (RMS) at 220 VAC
0° to 40°C (32° to 104°F)
471 mm × 451 mm × 461 mm (height × width × depth)
(18.54 × 17.76 × 18.15 inches)
25.5 kg (56 lbs 1 oz)
CD-ROM User's Guide, AC Cord
AC IN
Dell P992 Color Monitor Quick Setup Guide 1