Regular Maintenance; Changing Floor-Tool Blades; Refitting The Floor-Tool Blades - Numatic TTB 1840 Notice Originale

! !
1
Unscrew the four knobs securing the
blade holder (Fig.1).
Floor-tool Overview
1. Retaining knobs x 4
2. Front blade (slotted)
3. Blade carrier
4. Rear blade
5. Floor-tool main body
ALWAYS ENSURE THAT THE BATTERY IS REMOVED
PRIOR TO ANY MAINTENANCE OPERATION
A B
2
Remove the blade holder (Fig.2).

Refitting the Floor-tool Blades

Refit the blade holder, retain using the two outer knobs.
Ensure the slotted blade goes to the front of the floor-tool.
Note: The blades are designed to be reversible, thus extending their useful working
life.
Refit the floor-tool using the two central knobs to the floor-tool.
5
4
3
2
1

Regular Maintenance

Changing the Floor-tool
Blades
To change the floor-tool, firstly swing the
floor-tool clear of the machine. Undo the
two floor-tool retaining knobs (Fig.A).
Pull the floor-tool away from the machine
(Fig.B).
3
Replace the Squeegee blades using
(903531) replacement blade set (Fig.3),
fitting the blades on to the moulded location
lugs.
T 01460 68600
! !
19