Before First Use; Assembly - SilverCrest SDGS 1630 B1 Mode D'emploi Et Consignes De Sécurité

Before first use
NOTE
►
1) Remove the appliance from the packaging.
2) Remove all stickers and protective films from the appliance and accessories.

Assembly

1) Hold the telescopic shaft
left side. Check if the three locking clips
unlocked (fig. A).
2) Guide the telescopic shaft
upper side of the appliance base
the appliance base
3) Screw the screw cap for the telescopic shaft
shaft
SDGS 1630 B1
When you use the appliance for the first time, it might emit some smoke, a
harmless odour and a small amount of particles. This does not affect the
function of the appliance and does not last long.
z
q
so that it is firmly affixed to the appliance base
A
C
q
so that the power cable retainer
6
on the telescopic shaft
q
through the corresponding opening on the
z
. Then push the telescopic shaft
as far as it will go (see fig. B).
e
B
8
is on the
q
q
clockwise onto the telescopic
z
(fig. C).
GB │ IE
are
into
│ 9 ■