Remote Control; Replacing The Battery - Monacor PA-812DMP Mode D'emploi

SD/MMC
MIC 1
0 10
4 Operation
1) Before first-time operation, make sure that the
initial volume is not too high: Set the control
MASTER for the total volume approximately to
the position "9 o'clock" . Then switch on the
amplifier with the switch POWER . The green
power LED ON will light up .
USE ONLY WITH A 250V FUSE
2) Use the controls MIC..., LINE... and TEL to
24 V
mix the signal sources or to fade them in or
out . Set the controls of the inputs which are
not used to "0" .
3) Adjust the total volume with the control MAS-
TER . The LEDs "-30, -10, 0dB, CLIP" will indi-
cate the output level . To prevent distortions,
only turn up the control MASTER to such a
level that the red LED "CLIP" will not light up .
4) Use the controls BASS and TREBLE to adjust
the sound .
5) If the LED "PROT" lights up, the amplifier is
overheated or overloaded or has a short circuit
at one of the speaker outputs . In this case,
switch off the amplifier and have the fault
eliminated .

4.1 Remote control

Power supply of the remote control for the music
module is provided by means of a 3 V button
cell . If the remote control is supplied with the
battery inserted, remove the protective film (to
protect the battery against discharge) from the
battery support: The remote control will then
be ready for operation . When pressing a button
on the remote control, always point the remote
control at the amplifier . Make sure that there
are no obstacles between the amplifier and the
remote control .
If the remote control is not used for a longer
period of time, remove the battery as a precau-
tion . It may leak and damage the remote control .
10
USB
SD MP3
VOL− SCAN VOL+ MODE
MIC 2/LINE 1 MIC 3/LINE 2 LINE 3
0 10 0 10 0
230 V~
50 Hz
FUSE
SPEAKER OUTPUT
COM 4 Ω 8 Ω 16 Ω 70 V 100 V
LINE 4 TEL
10 0 10 0 10
FM
ANTENNA
1 ON - LINE 1
OFF - MIC 2
TEL INPUT MOH OUTPUT
2 ON - LINE 2
600 Ω/100 mV 600 Ω/1 V
OFF - MIC 3
COM HOT COM HOT
MIC2/LINE1

Replacing the battery

1) Push the latch of the battery holder to the
right (first arrow in the figure below) and re-
move the holder (second arrow) .
2) Remove the old battery and insert the new
battery (3 V button cell, type CR 2025) into the
holder with the positive pole facing upwards .
3) Push the holder back into the remote control .
BASS TREBLE
–10 +10 –5 +5
dB dB
PWR STOP MUTE
MODE
PREV NEXT
3 ON - PH.PWR ON
1 2
OFF - PH.PWR OFF 2 1
3
4 ON - PRIO. TEL
OFF - PRIO. MIC 1
1 2 3 4
4 5
OFF
1 2 3 4
ON ON
MIC3/LINE2 SELECT MIC 1
7 8
1. 2.
Never put discharged batteries in
the household waste . To protect the
environment, always take them to a
special waste disposal (e . g . collection
container at your retailer) .
PA-812DMP
ON
PROT
CLIP
0 dB
-10
-30
POWER
MASTER
0 10
EQ
0
AMP IN
3
L
6
R
LINE 3 LINE 4 OUTPUT
9