Interfacing; General; Balanced Input With Phantom Power; Balanced Input With No Phantom Power - Harman AKG C451 B Mode D'emploi

INTERFAcINg

4 Interfacing
4.1

General

General
The C451 B is a condenser microphone and therefore needs a
power supply. The microphone provides a balanced output on a
3-pin male XLR connector:
Pin 1: ground
Pin 2: hot
Pin 3: return
You can connect the microphone to balanced microphone inputs
with or without phantom power.
4.2

Balanced Input with Phantom Power

Balanced
Input with
Phantom
1) Use an XLR cable to connect the microphone to a balanced
Power
XLR input with phantom power.
2) Switch the phantom power on. (Refer to the instruction ma-
nual of the unit to which you connected your C451 B.)
C451 B
B18
2
3
1
Figure 1: Connecting to a balanced input
22
MIC 1 MIC 2 MIC 3 MIC 4
2
3
1
C451 B MANUAL
4.3

Balanced Input with No Phantom Power

If your mixer provides no phantom power, connect an optional
phantom power supply between the microphone and the mixer.
4.4

Connecting to an unbalanced inputs

C451 B Phantom
2
3
1
Figure 2: Connecting to an unbalanced input
Use a cable with a female XLR connector and TS jack plug:
1) On the XLR connector, use a wire bridge to connect pin 1 to
pin 3 and the cable shield.
2) Connect the inside wire of the cable to pin 2 on the XLR
connector and the tip contact of the jack plug.
Unbalanced cables may pick up interference from stray magnetic
fields near power or lighting cables, electric motors, etc. like an
antenna. This may introduce hum or similar noise if you use a cable
that is longer than 16 feet (5 m).
C451 B MANUAL
INTERFAcINg
Balanced
Input with
No Phantom
Power
INPUT 1 INPUT 2 INPUT 3 INPUT 4
T
S T
S
23