NORAUTO MS-318E Manuel D'utilisation page 12

g) If devices are provided for the connection of dust extraction and collection facilities,
ensure these are connected and properly used. Use of dust collection can reduce
dust-related hazards.
4) Power tool use and care
a) Do not force the power tool. Use the correct power tool for your application. The
correct power tool will do the job better and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off. Any power tool
that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool's operation. If
damaged, have the power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended could result
in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Specific instructions for the tool
• Wear personal protective equipment (such as gloves, mask, etc).
• The external flexible cable or cord of this product can not be replaced, if the cord is
damaged, the product shall be scrapped.
Technical data
- Voltage: 220-240V~ 50/60Hz
Noise emission:
- Sound pressure level LpA: 59,5dB(A) - Uncertainty K: 3dB(A)
- Sound power level LwA: 70,5 dB(A) – Uncertainty K: 3dB(A)
Vibration value:
- Main handle: 16,284m/s² - Uncertainty K: 1,5m/s²
- Auxiliary handle: 15,762m/s² - Uncertainty K: 1,5m/s²
The declared vibration total value has been measured in accordance with a standard
test method and may be used for comparing one tool with another. The declared
vibration total value may also be used in a preliminary assessment of exposure.
The vibration emission, during actual use of the power tool, can differ from the
declared total value depending on the ways in which the tool is used; and
It is necessary to identify safety measures to protect the operator based on an
estimation of exposure in the actual conditions of use (taking account of all parts of
the operating cycle such as the times when the tool is switched off and when it is
running idle in addition to the trigger time).
It is recommended to wear an ear protection.
- Power: 90W - Rated non-load speed: 3500/min
11