Joie Gemm Mode D'emploi page 8

4. Line up the ISOFIX connectors with
the ISOFIX guides, and then
click both ISOFIX connectors into
the ISOFIX anchor points.
!
Make sure that both ISOFIX
connectors are securely
attached to their ISOFIX anchor
points. The colors of the
indicators on the both ISOFIX
connectors should be
-1
completely green.
14
!
Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
5. Please refer to step 2 in section 'a.
Installation with 3-point-belt'
for adjustment of load leg.
The completely assembled base is
shown as
15
!
The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points.
!
The load leg must be installed
correctly with green indicator.
-2
15
6. Please refer to step 5, 6 in section
'a. Installation with 3-point-belt'
to use the infant carrier module.
13
14
14
1
15
-1
15
1
2
7. To remove the base, press the
-1
secondary lock button
16
-2
first and then the button
16
on the ISOFIX connectors before
removing the base from the vehicle
seat.
16
8. Press the ISOFIX releasing button
to fold the ISOFIX.
17
16
2 1
17
2
1
2
14