Joie Gemm Mode D'emploi page 7

The installed base is shown as
!
Please ensure that there is no gap
between the vehicle seat and the
bottom of the base.
!
The safety belt must go under the
lock-off, not over the lock-off.
-1
8
!
The safety belt must be locked into
-2
the buckle.
8
!
The load leg must be installed
correctly with green indicator.
-3
8
5. Push the infant carrier module
down into the base , if the infant
9
child restraint is secure, the infant
child restraint indicator shows
green. If the infant child restraint is
not secure, the indicator shows
red.
10
!
Pull up on the infant carrier
module to be sure it is securely
latched into the base.
11
8
8
1
2
9
10
6. To release the infant carrier
module, pull the infant carrier
module up while squeezing the
infant carrier module release
button.
11
b. Installation with
ISOFIX System
see images
12
1. Unfold the load leg from storage
3
compartment.
2. Fit the ISOFIX guides with the
ISOFIX anchor points.
The ISOFIX guides can protect the
surface of the vehicle seat from
being torn. They can also guide the
ISOFIX connectors.
3. Rotate the ISOFIX connectors 180
degrees until they are pointing
in the direction of the ISOFIX
guides.
13
11
-
17
12
5
12
13
2
1
12