Notes On Safety; Symbols And Icons; Symbols On The Device - Parkside PWSA 12 B1 Traduction Des Instructions D'origine

GB IE
This device can only be operated with the
following rechargeable batteries:
PAPK 12 A1, PAPK 12 A2, PAPK 12 A3,
PAPK 12 B1, PAPK 12 B2, PAPK 12 B3,.
This type of battery may only be charged
with the following chargers:
PLGK 12 A1, PLGK 12 A2, PLGK 12 B2.
PAPK 12 A1
Charging
PAPK 12 A2
time (h.)
PAPK 12 A3
PLGK 12 A1
PLGK 12 A2
PLGK 12 B2
The vibration values represent maximum
values which have been determined with
the supplied blade. The actual vibration
values may vary depending on the used
accessories.
The vibration values are still affected by the
handling for the user's.
Cutting disc PTS 76 (included):
Idling speed n ............. max.20300 min
0
Disc speed ....................... max. 80 m/s*
Outer diameter ........................ Ø 76 mm
Bore hole ................................ Ø 10 mm
Thickness ...................................... 1 mm
*
The grinding disc must keep a rotational
speed of 80 m/s.
You can use all grinding tools mentioned in
these operating instructions.
Levels of noise and vibration were deter-
mined according to the norms and regula-
tions in the declaration of conformity.
The vibration emission value has been
measured according to a standardised test-
ing method and may be used for compari-
son with another electric tool.
26
PAPK 12 B1
PAPK 12 B2
PAPK 12 B3
1 2
1 2
0,5 1
The indicated vibration emission value may
also be used for an introductory assess-
ment of the exposure.
Warning:
The vibration emission value whilst
actually using the electrical tool
may vary from the given values in-
dependently of the type and way in
which the electric tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).

Notes on safety

Caution! When using power tools,
-1 observe the following basic safety
measures for the prevention of
electric shocks and the risk of injury
and fire.
Please read all these instructions
before using this electric tool and
please keep the safety instructions.

Symbols and icons

Symbols on the device:

Warning!
Read the manual!