Leckey Mygo Notice D'utilisation page 47

10.7 Adjusting the
Dynamic Backrest
To achieve the required amount of dynamic
movement loosen the handle (a), slide to
the required position and retighten securely.
To return the backrest to a static position,
loosen the handle (a), slide the backrest strut
to the bottom, retighten the handle.
To angle adjust the backrest where a
dynamic backrest has been fitted, you use
the handle at the base of the backrest. Pull
the locking pin (c) and twist and unlock. Lift
up the handle (b) and adjust the backrest.
Pull the locking pin (c). Ensure that the
locking pin is secure.
The range of the backrest angle and the
range if dynamic movement are a maximum
of 30°, i.e. if the backrest is upright, a full
30° is available on the dynamic system. If
the backrest angle is at 10° then only 20°
of movement is available with the dynamic
backrest and so on.
The backrest must be in the upright
position with the dynamic function
locked off (i.e. the handle (a) to the
lowest position on the backrest supine)
and ensure the locking pin (c) is
engaged when the seating system is
used in transport.