Fracarro HEAD LINE SIG7900 Instructions D'emploi page 20

Select the module to be
programmed/visualised
following menu 3.1
The selected module can be
programmed or checked
Allows a new scan of
all devices connected to
the headend, i.e. after
installation a new module.
After this operation the TPE
receives a revised map
Allows the settings to be copied from
module source to another module
destination (copy/paste from one
module to another). It is possible
to copy/paste only if the
modules are the same type
Allows the setup address
to be changed on an
interconnection module
Resets the selected
module without switching
the power off
3.0 CENTRAL SETUP
HEADEND SETUP
MODULE SELECTION
NAVIGATION
(SEE 3.1)
YES
SOFTWARE VERSION
INTERCONN. MOD.
ROW
HEADEND
RESET NET MAP
SCANNING
CHOOSING THE MODULE
COPY
FROM WHICH TO COPY
THE INFO (SEE 3.1)
FACTORY SETUP
ALL DEVICES
CENTRALE
INTERCONNECTION
ADDRESS SETUP
MODULE ROW 1
INTERCONNECTION
MODULE ROW N
RESET DEVICE ALL DEVICES
0
THE SELECTED
NO SEE MODULEʼS OPERATING
MODULE IS AN
INSTRUCTIONS FOR INFO
INTERCONNECTION
REGARDING PROGRAMMING
MODULE?
SIG7900 V0.1
interconnection module
Visualisation of the row
number associated to the
1
1..15
interconnection module
SEARCH DEVICES
CHOOSING THE MODULE
TO WHICH TO COPY
THE INFO (SEE 3.1)
DEFAULT DATA
LOADING OF TPE
SELECTION OF THE MODULE
FOR FACTORY SETUP (SEE 3.2)
DEFAULT DATA
LOADING OF TPE
SET DEVICE ADDR.
Current: 1 New: 3
SELECT THE MODULE
TO RESET (SEE 3.2)
RESET OF THE
MODULE
Visualisation of the
software version of
AUTOCONFIG
CONFIRMING COPY
FROM MOD. X TO MOD. Y
CONFIRMING
YES NO
COPY FROM.. TO .. ?
YES = NO =
FACTORY
YES NO
SETUP?
YES = NO =
RESET
YES NO
DEVICE?
YES = NO =