Installation Instructions; Sensor Installation - Elektrotechnik Schabus GX-HS Notice D'utilisation

INSTALLATION INSTRUCTIONS

The GAS ALARM GX-HS and the sensor may be installed only in dry, interior rooms and
must be correctly placed according to the type of gas to ensure faultless operation of the
alarm system.
The installation shall be performed by qualified personel. Please note the
five safety rules!
Snap-on fitting on mounting rails
The GAS ALARM GX-HS is installed into equipment racks and conduit boxes (mounting rail
35 mm standard)

Sensor installation

Depending on the type of sensor connected, the device detects different gases, e.g. city
gas and natural gas (methane/butane), carbon monoxide and smoke or inert gases. For
each type of sensor, there is a prescribed mounting height to take account of the differing
properties of the gases.
It is essential to observe the prescribed mounting height! Please note the
operating instructions of the sensor you wish to use and you will see the
specified mounting height!
storage function ON/OFF
Buzzer connection
(optional)
14 = GND
15 = + buzzer
L
230 V AC
Wire jumper for
13 14 15 16 17 18 19 20 21 22 23 24
GAS ALARM
GX-HS
Relay
5A/230V
N
Sensor con guration
22 = brown (5 V)
23 = white (sensor)
24 = green (GND)
Gas sensor
Accessoires:
magnetic cut-o valve
Gas supply
line
Gas leakage