Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
Do not use battery water, water from tumble dryers or water
with additives such as cleaning agents, alcohol, fabric
softener or other chemicals. They could cause hazards or
damage to the appliance.
WARNING: Risk of injury!
1. Disconnect the mains plug from the wall socket.
2. Only open the appliance after the pressure has been
released. Press the steam button to do so.
3. If the appliance is still warm, wait approx. 5 minutes until
removing the lid.
4. Press down the lid and turn it anticlockwise to remove.
NOTE:
For your safety, this lock features a release mechanism.
If the pressure in the boiler is still too high, the lock can-
not be opened.
5. Pour any remaining water from the boiler in order to avoid
overfilling.
6. Use the funnel to fill the boiler with a maximum of approx.
220 ml of water.
7. Attach the lid by turning it clockwise and applying pressure
at the same time.
Installation of accessories
NOTE:
Observe the arrow markings on both the appliance and ac-
cessories.
1. Insert the locking catches of the hose as far as they will go
into the connecting tip of the appliance. Secure the hose by
turning it clockwise.
2. Insert the locking catches of one of the attachments as far
as they will go into the connecting tip of the hose. Secure
the attachment by turning it clockwise.
•
You may also connect the attachments directly to the appli-
ance. Connect as described above.
•
Attach the angled nozzle or the circular brush on top of the
nozzle adapter, if required.
•
In order to clean sensitive surfaces, attach the fleece cloth
to the cleaning attachment.
•
In order to use the window cleaning attachment, hook it into
the cleaning attachment (without the fleece cloth).
Electrical Connection
1. Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
2. Lock the steam button. Push the lock of the steam button
to the right.
3. Connect the device to a duly installed protective contact
socket.
Using the Device
WARNING: Risk of scalding!
Keep the device straight. Tilting the device by more than 45°
can cause hot water to leak from the device.
CAUTION:
Before you begin cleaning you should test the materials to
be cleaned as to their suitability for cleaning with steam. Do
not hold the steam nozzle for too long and too close in one
position.
•
When the plug is connected to a wall socket, the water in
the boiler starts heating up. The heating control lamp lights
up.
•
Pressure starts building up in the boiler after approx.
3-4 minutes. When the appliance is ready for use, the
control lamp turns off.
•
Push the lock of the steam button to the left.
•
Press the steam button to generate steam.
NOTE:
Using the appliance with the maximum water amount and in
continuous operation will allow for steam generation of up to
8 minutes.
Filling the Water Tank during Operation
No steam will be discharged if the water tank is empty. The
water has to be filled up as follows:
1. Remove the mains plug from the socket!
2. Fill fresh water into the tank as described in the chapter "Fill
in Water" (steps 1-7).
3. Connect the mains plug to the wall socket to continue
operation.
When you have finished using the device
1. Remove the mains plug from the socket!
2. Let the unit cool down completely.
3. Empty the water tank.
27
Publicité
Table des Matières
