The year flashes on the display.
• Select the year using the M1/M2 memo-
ry buttons and confirm with the START/
STOP button
.
The month flashes on the display.
• Select the month using the M1/M2 memo-
ry buttons and confirm with the START/
STOP button
.
The day flashes on the display.
• Select the current day using the M1/M2
memory buttons and confirm with the
START/STOP button
If you have set the 12h hour format, the month is
displayed before the day.
The hours flash on the display.
• Select the current hours using the M1/
M2 memory buttons and confirm with the
START/STOP button
The minutes flash on the display.
• Select the current minutes using the M1/
M2 memory buttons and confirm with the
START/STOP button
.
.
.
The Bluetooth
symbol flashes on the display.
®
• Use the M1/M2 memory buttons to select whether
automatic Bluetooth
tooth
symbol flashes) or deactivated (Bluetooth
®
symbol is not shown) and confirm with the START/
STOP button
Bluetooth
transfers will reduce the battery life.
®
Operation with the mains part
You can also operate this device with a mains part. When do-
ing so, there must not be any batteries in the battery compart-
ment. The mains part can be obtained from specialist retailers
or from the service address using order number 071.51.
• To prevent possible damage to the device, the blood pres-
sure monitor must only be used with the mains part de-
scribed here.
• Insert the mains part into the connection provided for this
purpose on the right-hand side of the blood pressure mon-
itor. The mains part must only be connected to the mains
voltage that is specified on the type plate.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it from
the blood pressure monitor. As soon as you unplug the
mains part, the blood pressure monitor loses the date and
time setting but the saved measured values are retained.
26
data transfer is activated (Blue-
®
.
®