Hendi 272404 Mode D'emploi page 8

STEP 4: Unscrewing 2pcs Standard Screws and Washers (BB) as arrow showed from Support Bar – UPPER (E). Attach
Flame Screen (B) to the top of Whole Support Bar and fix by using 2pcs standard screws and washers. Repeat this
step to connect Flame Screen (B) with left 3sets Whole Support Bar.
EN
STEP 6: Unscrews 8pcs Standard Screws and Washers (BB) from top of tank housing assembly (K). Lift the assembled
upper parts of heater and place them on the tank housing. Push support bar as photo showed and make sure
each support bar inserts into slot. Fix at bottom position by using 8pcs standard screws and washers (BB).
8
STEP 5: Place Reflector (A) on the Flame Screen (B) and fix
by using 4pcs M6 CAP NUT (AA).