Hendi 272404 Mode D'emploi page 4

¨ Heater does not reach a proper temperature. A temperature less than 5ºC will cause
restricted heat flow and the appliance will not work properly.
¨ The appliance starts making popping noises during use (a slight popping noise is nor-
mal when the appliance is extinguished).
• The regulator & hose assembly must be located out of pathways where people may trip
over it or in area where the hose will not be subject to accidental damage.
• Any guard or other protective device removed for servicing the heater must be replaced
before operating the heater.
• Children and adults should be warned of the hazards of high surface temperatures and
should stay away to avoid burns or clothing ignition.
• Young children and pets should be carefully supervised when they are in the area of the
heater.
• Clothing or other flammable materials should not be hung from the appliance, or placed
on or near the appliance.
• Do not place articles on or against this appliance. Certain material or items when stored
under or near this appliance will be subjected to radiant heat and could be seriously
damaged.
• Do not use or store flammable materials near this appliance.
• Do not spray aerosols in the vicinity of this appliance while it is in operation.
• Always maintain at least 0.9m clearance from combustible materials.
• Always position the appliance on a firm level surface. An amply ventilated area must have
EN
a minimum of 25% of the surface area open. The surface area is the sum of the walls
surface.
• The injector in this appliance is not removable and the injector is only assembled by
manufacture. This appliance is forbidden to convert from one gas pressure to another
pressure.
• Do not connect the gas cylinder directly to the appliance without regulator.
4