Possible Faults; Technical Data - ATIKA DKV 400-2 Notice Originale

Before each fault clearance
 switch off device
 wait for the shutdown of the saw blade
 pull out main plug

After each fault clearance, put into operation and recheck all security installations.
Fault
After switching on, the
machine does not start or
switches off automatically.
Machine stops while cutting
Work piece jams when
pushing forward or pulling
back
Burn marks at the cut edges  Saw blade is unsuitable for the cutting
Chip exit blocked
Type / Model
Year of construction
Motor output P
1
Mains voltage
Mains frequency
No-load speed n
0
Protection degree
Saw blade length (total length)
Stroke movement
Cutting height at 90° (max.)
Cutting height at 45° (max.)
Bevel cut adjustment
Table size
Overhang
Floor space
Sound power leve L
WA
Sound pressure level L
PA
Uncertaintity K /
WA PA
Weight
Exhaust outlet 
Commercial, small dust collectors or industrial vacuum cleaners are used for vacuuming.
22
Possible cause
 Power failure
 Extension cable defect
 Motor or switch defect
 Saw blade blunt
 Saw blade blunt
task or blunt
 No exhaust suction connected
 Suction too weak

Technical Data

Possible faults

Removal
 Replace fuse
 Check cable, no longer use defect cable
 Have motor or switch checked by an approved
electrician or replaced by original spare parts
 Replace saw blade
 Hold the workpiece firmly and switch the motor off
immediately. After this renew saw blade.
 Exchange saw blade
 Switch off saw and remove chips
 See "Safe working"
DKV 400-2
see last page
120 W (S6 – 30%)
220 - 240 V~
50 Hz
500 – 1700 min
–1
IP 20
127 mm (133 mm)
21 mm
approx. 57 mm
approx. 27 mm
0° – 45°
approx. 415 x 255 mm
406 mm
405 x 250 mm
79.9 dB(A)
66.9 dB(A)
3.0 dB(A)
approx. 12.7 kg
36 mm