Initial Operation; Switching On The Device; Cleaning And Maintenance - CTC CLATRONIC DR 2930 Mode D'emploi

Initial Operation

Filling up the Heating Boiler before Use!
CAUTION:
• Before the tank lock is opened the power plug must
be removed from the socket. Please make sure the
device is depressurized by pressing the steam switch.
• Before unscrewing the lock (3) proceed as follows:
1. Remove the power plug from the socket.
2. Release the pressure by using the steam switch (4).
3. If the device is still warm, please wait 5 minutes before
removing the seal completely. Press the seal downwards
and turn.
WARNING:
• Danger of Injury!
• Please open the safety lock (3) only when no more
steam comes out of the nozzle.
4. Shake any residual water out of the kettle (1). Then fi ll the
measuring beaker (8) and pour the water into the kettle. Use
a funnel if necessary. Re-fasten the safety lock (3).
Attachment of the Individual Accessories
Brush (10) and Angle Attachment (11)
Both attachments can be joined to the nozzle attachment (12)
on the hexagonal section.
Nozzle Attachment, Hose, Cleaning and Non-woven Fabric
Attachment
1. Before attaching the accessories please look at the ope-
nings on the connecting nozzle. The pins on the accessory
must be in line with the openings of the connecting nozzle.
Push the accessory on to the device as far as it will go.
2. Turn the accessory through approximately 90° in a
clockwise direction. The accessory remains locked in this
position.
3. The nozzle attachment can be used on the hose or directly
on the device.
4. The hose (7) must be attached to the connection nozzle (2).
The nozzle attachment and the universal cleaning attach-
ment (13) can be fi xed to the end of the hose. The universal
cleaning attachment should be used either together with
the non-woven fabric attachment (9) or with the window
cleaning attachment (14). The non-woven fabric attachment
is intended for cleaning sensitive surfaces such as sofas
and armchairs.
5. The window cleaning attachment (14) is hooked under the
cleaning attachment (13).
Attachments:
Nozzle attachment:
Brush attachment:
Angle attachment:
26
05-DR 2930 NEU.indd 26 05-DR 2930 NEU.indd 26
for cleaning crevices, for
example, bathtub edges etc.
for areas which are diffi cult
to access.
for areas which are diffi cult
to access, e.g. radiators.
Non-woven fabric attachment:
Window cleaning attachment:
Universal cleaning attachment:

Switching on the Device

• Before inserting the mains lead into the socket, check
whether the voltage you intend to use complies with that of
the machine. For details see the machine label.
• Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.
• After about 3-4 minutes the pressure in the boiler has built
up. Please press the steam switch (4) to produce steam.
Filling up the Water Boiler when using the Device
If there is no more water in the vessel no steam is emitted when
the steam switch (4) is pressed. The water has to be fi lled up
as follows:
1. Pull the power plug out of the socket!
2. Wait for approximately 5 minutes and release the resi-
dual pressure with the steam switch!
3.
WARNING:
Unscrew the safety lock (3) slowly and wait for a few
seconds before opening it completely until the excess
pressure has escaped.
4. Fill fresh water from the measuring beaker (8) by means of
the funnel into the boiler. Do not overfi ll! Do not exceed the
amount of water indicated on the measuring beaker! Take
care of water splashes that might come out of the boiler. In
order to prevent the water from splashing it should be fi lled
into the funnel slowly after the safety lock has been opened.
5. Fasten the safety lock again.
6. Insert the power plug back into the socket.

Cleaning and Maintenance

WARNING:
Cleaning and maintenance must only be carried out when the
power plug is removed from the socket.
• Before putting the device away or cleaning it, it has to be
allowed to cool down completely.
• Please clean the device and the accessories only with a
slightly moist cloth.
• Do not use strong cleaning agents of solvents for cleaning.
• In order to guarantee a long and trouble-free working life,
lime residues have to be rinsed out of the boiler once a
month. Please do not use vinegar or other anti-liming
agents.
protective non-woven fabric
attachment for sensitive
surfaces.
for window cleaning, shower
cabinets etc.
for larger surfaces such as
glass panes or tiles.
25.02.2009 16:19:53 Uhr 25.02.2009 16:19:53 Uhr