Preparing For Use; Inserting / Replacing The Batteries - SilverCrest HG01910A Instructions De Montage, D'utilisation Et Consignes De Sécurité

Preparing for use

Preparing for use
For first time use, please remove the protective foil from the name
plate of the transmitter.
12

Inserting / replacing the batteries

Insert the batteries to provide power to the device before preparing
it for use.
CAUTION! Use the above-indicated battery types only. Failure to
observe this advice may result in damage to the product.
Receiver:
Remove the battery compartment cover
Remove the used batteries, if present.
Insert 2 batteries (1.5 V
Note: Ensure correct polarity. This is indicated in the battery
compartment
Close the battery compartment
Transmitter:
Remove the holder
Remove the used batteries, if present.
Insert a battery (3 V
The side marked "+" must face upwards.
Fasten the holder
26 GB/IE
(direct current), type AA).
.
10
from the back of the transmitter.
15
(direct current), type CR 2032).
of the receiver back on to the back of the device.
15
from the back of the device.
9
.
10