Erreka VIVO-M201 Manuel De L'installateur page 35

Connection of photocells
FCA2 COM FCC2 SCA
P1 P2 P3 P4 P5 P6 P15 P14 P16 P7 P8 P11 P12 P22 P23
24Vac
ST1 FT1 ST2 FT2 FCA1 FCC1 STOP LOCK
G4 G5 G6 G1 G2 G3
G7 G8 G9 G10
N L
POWER
Courtesy
Lamp.
MOTOR2 (G2-G1-COM) MOTOR1 (G2-G1-COM)
Light
DIP2
DIP1
6 5 4 3 2 1
12/24V NC/NA TEST
P167G

We recommend installing interior and safety on
closings. If only one is installed, install the
exterior one. If a safety device is not installed,
make an electrical bridge in the corresponding
terminal of the control board.

Shown below is an example of the connections of a
FT02 photocell as an exterior safety device.
1 Connect the NC contacts of the photocell (1) in the
corresponding terminal of the control board.

Correctly programme the microswitches DIP1 and
DIP2 (see the photocell instructions).
2 The 24Vac terminal can be used to feed the
photocell.

The bridge (2) is necessary if an interior photocell is
not installed.
INSTALLATION
Control board VIVO-M201(M)
31