Preparing The Unit; Daily Maintenance - MIRKA Pad Washer Notice D'utilisation

POLARSHINE PAD WASHER OPERATING INSTRUCTIONS

PREPARING THE UNIT:

Remove the main housing cover lid from the bucket, release the housing clamps located on
each side of the plate, and lift the lid straight up..
CAUTION: DO NOT LIFT WHILE HOLDING THE HOUSING CLAMPS. DAMAGE TO THE UNIT MAY
OCCUR! GRASP AND LIFT THE COVER LID ONLY.
Remove pad cleaning unit from bucket by lifting from the two triangular shaped holes in the
pad cleaning plate.
Fill bucket with 10-11 liters of water.
Re-place the Pad Cleaning unit into bucket and push straight down.
Place cover lid on bucket rim and close housing clamps to lock into position.
NOTE: TO GET THE BEST PERFORMANCE FROM YOUR POLARSHINE PAD WASHER, BE SURE TO
PLACE THE ARROW MARK ON LID IN CENTER ABOVE GRAY FLUID PUMP WHEEL.
ADJUSTABLE HEIGHT
A new POLARSHINE PAD WASHER is factory set at an average pad washing height of 7, 5 cen-
timeters. If another opening height is desired, simply remove the pad cleaning unit from buck-
et, remove the three leg adjustment screws and replace them in the desired location.
TO OPERATE THE POLARSHINE PAD WASHER:
CLEANING A PAD:
1. Open the covers on lid and insert the polishing pad attached to polishing machine into the
Polarshine Pad Washer.
2. Close covers and operate polishing machine while keeping the pad fl at against cleaning
wheels.
3. Run the polishing machine at app. 1000 – 1200 rpm gently in a circular motion.
DRYING A PAD:
1. Lift polishing machine and pad slightly above the top of the fl uid pump wheel. Keep the
covers on lid closed.
2. Run polishing machine for 15 seconds.
3. Stop the polishing machine - Open the covers on lid – Remove
the machine from the Polarshine Pad Washer.

DAILY MAINTENANCE:

Remove wool fi bers stuck to cleaning wheels
In frequent use, change water daily
4