Sony WRR-855S Mode D'emploi page 12

1) The distance depends on the operating
environment and conditions.
Refer to the supplied leaflet "Sony Wireless
Microphone System Frequency List" for details on
the selectable channel groups and channels.
1
Turn the POWER switch to ON.
The version number of your tuner unit
("U62," for example) appears in the
LCD panel, then the display changes to
the status shown before the tuner unit
was previously turned off.
Note
Before operating the POWER switch,
be sure to turn down the input volume
on the connected device. If not, noise
may be produced.
2
Press and hold down the GP button for
more than three seconds.
The tuner unit goes to the channel
group selection mode and the channel
group indication flashes.
The group/channel indications for U62
model are shown.
3
Press the + or – button to select the
channel group.
12 Settings
Pressing the + button cyclically
changes the indication in the order
shown in the tables in the supplied
leaflet "Sony Wireless Microphone
System Frequency List."
Pressing the – button cycles the
indication in the opposite direction.
Hold down the + or – button to
continuously change the indication.
When no buttons have been pressed for
five seconds, the channel group
selection mode is automatically
cancelled and the lowest frequency
channel in the group selected at that
time is displayed.
For the group 00, however, the channel
previously set in group 00 appears.
4
When the desired channel group
number appears, press the CH button.
The selected channel group is entered
and the tuner unit goes to the channel
selection mode and the channel
number indication flashes.
The group/channel indications for U62
model are shown.
5
Press the + or – button to select the
channel number.
The indication cyclically changes in
the order shown in the tables in the
supplied leaflet "Sony Wireless
Microphone System Frequency List."