STEINEL IS 3180-24 Consignes D'installation page 4

6
Mounting
IS 3180-24 IS 3360-24 IS 345-24
Placement guidelines
• Detection lens must have a
clear, unobstructed view of
the detection area; the sensor
does not detect from behind
obstacles, such as walls or
panes of glass
• Ideal mounting height is 8-12
feet
www.steinel.net
(800) 852-4343
• The site of installation should
be at least 20 inches away
from another light because
heat radiated from it may
activate the system
• An optional corner wall mount
(product no. 648015 black or
648114 white) is available for
installing the IS 3180-24 in
corners.
Installation
Installation - wall or ceiling
mount with screws
• Confirm power is off at the
circuit breaker
• Install power pack and run
low voltage wire to the sensor
location
• Remove the decorative cover
• Remove the screws securing
the front and back housings
• Separate the top housing from
the back housing
• Fasten the back housing to
the wall with screws through
the pre-punched holes (60 mm
or 2 3/8 in apart)
wires 200 mm
• Connect wiring
• Reattach the front housing to
the back housing and secure
with screws
• Snap the decorative cover back
in place
www.steinel.net
(800) 852-4343
7