Horizon Hobby Dynamite FUZE 130A Brushless ESC Manuel D'utilisation page 10

EN
Symptom
Steering servo operates but the
motor does not run
Steering and motor do not
function
Vehicle does not operate at full
speed
Motor slows but will not stop
Decreased transmitter range
10
Solution
Ensure all ESC programming matches your installed systems
requirements for safety
Ensure all receiver connections are correct and secure
Test the motor apart from the vehicle system and repair or replace
motor as needed
Recharge or replace batteries
Ensure all motor connections are secure
Adjust throttle travel or other throttle settings on the transmitter
and the ESC
Ensure all connections to receiver are correct and secure
Refer to manufacturer's instructions to repair or replace
transmitter
Recharge or replace batteries
Recharge or replace batteries
Ensure ESC programming is correct for voltage and battery
Adjust transmitter settings, such as trim, throttle travel, etc.
Ensure ESC settings are correct for system
Calibrate throttle control to ESC
Adjust transmitter settings, such as trim, throttle travel, etc.
Ensure ESC settings are correct for system
Calibrate throttle control to ESC
Repair or replace system antennas
Repair or replace damaged motor, wiring and electrical parts
Move receiver or adjust antenna location so that no metal parts
are between the antenna and the transmitter
Recharge or replace batteries
Refer to receiver and transmitter manufacturer's instructions to
adjust reception or change to a free and open radio frequency