Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
Close the external connector cover and press down
while sliding it to make sure it locks into place.
When using batteries
For the camera in this system, you can use four size AA
Nickel Metal Hydride batteries available commercially.
Use the following steps to insert the batteries into the
camera.
Note
Use only Sony NH-AA (max. 2700 mAh) batteries.
1
Slide the battery compartment cover at the rear of
the camera to open it.
2
Insert the four size AA batteries.
3
Close the cover and press down while sliding it to
make sure it locks into place.
Power Status Indicators
When using an AC power supply
The
icon appears at the bottom right of the camera's
LCD.
When using batteries
The following icons appear at the bottom right of the
camera's LCD. Use these to get a general idea of when
to replace the batteries.
Indicator
The batteries are sufficiently charged.
The battery charge is getting low, but you
can continue camera operations. Ready the
AC power adapter or a new set of
batteries.
The battery charge is low, and operation
will be disabled shortly. Use the AC power
adapter or replace the batteries.
The batteries are fully discharged.
(flashing)
Operation is disabled.
Notes
• Connecting the AC adapter while the batteries are
inside the camera will not recharge the batteries. To
recharge the batteries, use the specifically designed
battery charger.
• The above battery indicator icons are optimized for
Sony Nickel Metal Hydride (typ. 2000 mAh /
typ. 2500 mAh) batteries. Be aware that batteries may
become discharged without indication when using
other battery types.
Power status
Preparations
15
Publicité
Table des Matières
