Troubleshooting; Possible Causes - Whirlpool WGTLV27FW Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour WGTLV27FW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting — Washer
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
If you experience
Vibration or Off-Balance
Check the following for
proper installation or
see "Using Your
Washer" section.
Noises
Clicking or metallic
noises
Gurgling or humming
Humming
Water Leaks
Check the following for
proper installation:
Washer not performing as expected
Washer won't run
or fi ll, washer stops
working
18

Possible Causes

Feet may not be in contact with the
fl oor and locked.
Washer/dryer may not be level.
Load could be unbalanced.
Objects caught in washer drain
system.
Washer may be draining water.
Washer is in sensing spin.
Washer not level.
Fill hoses not attached tightly.
Fill hose washers.
Drain hose connection.
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded as
recommended.
Check for proper water supply.
Front and rear feet must be in fi rm contact with fl oor, and
washer/dryer must be level to operate properly. Jam nuts must
be tight against the bottom of the cabinet.
Check fl oor for fl exing or sagging. If fl ooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer/dryer will reduce
sound.
See "Level the Washer/Dryer" in Installation Instructions.
Load dry items in loose heaps evenly around basket wall.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Do not tightly pack. Avoid washing single items.
See "Washer Cycle Guide" and "Using Your Washer" in this Use
and Care Guide.
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
It may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming
sound with periodic gurgling or surging as fi nal amounts of
water are removed during the Spin cycle.
You may hear the hum of the sensing spins after you have
started the washer. This is normal. Sensing spins will take
several minutes before water is added to the washer.
Water may splash off basket if washer is not level. Check that
load is not unbalanced or tightly packed.
Tighten fi ll-hose connection.
Make sure all four fi ll hose fl at washers are properly seated.
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Do not place tape over drain opening.
Water can back up out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe,
water pipes, and faucets.)
Improper loading can cause basket to be out of alignment
and cause water to splash off tub. See "Using Your Washer"
for loading instructions.
Both hoses must be attached and have water fl owing to
inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water fl ow.
Solution

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wetlv27fw

Table des Matières