Lightmaxx LIG0015077-000 Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Safety Instructions! Please read before connection and operation!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: To prevent the risk of electrocution, do not open
the device.
Please leave all maintenance and repairs to a qualifi ed service
workshop or contact your distributor.
The lightning fl ash symbol warns the user about
non-insulated current and the risk of electrocu-
tion.
The exclamation mark symbol warns the user
about important maintenance and operating inst-
ructions in the manual.
Intended for indoor and outdoor use.
Read the manual.
This symbol indicates the minimum distance to
illuminated objects.
Please recycle the packaging correctly to protect the
environment.
Occasionally a new product may cause undesirable
odours or even emit smoke for a short period of time.
This reaction is normal and will disappear after a few
minutes.
To prevent condensation from forming in the device,
please allow the device to adapt to the surrounding
temperature before operating.
Please position the device in a well ventilated area,
beyond the reach of fl ammable materials or liquids.
Do not block any ventilation openings, as it may cause
over-heating.
Please remove the power cable if the device is not
operated for extended periods of time or maintenance is
to be conducted.
This device is designed to operate in environments with a
maximum temperature of 40° Celsius.
The installation of the device is not to be conducted by
inexperienced persons and must adhere to the mechani-
cal and electrical safety standards of the local law.
In case of a damaged power cable, it must be replaced
by an original replacement part from the manufacturer.
Ensure that the supply voltage does not exceed the
voltage capacity indicated on the housing of the device.
7
In case of failure of the device, please contact the distri-
butor and stop all operations of the device immediately.
The device must keep a minimum distance of one metre
from fl ammable materials or liquids.
WARNING: Do not look directly into the light source!
Do not operate this device in the presence of persons suffering
from epilepsy!
OVERHEAD INSTALLATION
The installation must be performed exclusively by qualifi ed
personnel. Incorrect installation can cause serious injuries or da-
mage. Note the load limits of the selected installation position.
Ensure that during installation or dismantling/ maintenance
there are no unauthorized persons below the device.
Manufacturer: MUSIC STORE professional GmbH,
Istanbulstraße 22-26, 51103 Köln, Germany

Publicité

Table des Matières
loading

Table des Matières