YureHome 11252 Mode D'emploi page 23

Plug output jack f adapter into power cord jack of the foot massager, then plug
in-put jack of adapter into AC power socket, the buzzer makes a soung of "di",
the LED indicators of power flash, the foot massager is Reddy for working now.
MANUAL WORKING MODE
Turn on the power button, manual working mode Works:
1. Press "KENADING" button can select two level massage Speed: Slow or
Fast.
2. Press "AIR PRESSURE" button can select six level air pressure intensities,
Each mode, 'Low', 'Middle' and 'High', has two intensities marked in green
and red when are activated.
3. Press "heating" button can select low or high temperature.
By default, the massage begins with all levels to a minimum, set the parameters
to your liking: massage, acupressure and heat.
AUTOMATIC WORKING MODE
To activate an automatic mode, turn on the device and then press the 'Auto' (P)
button and select the mode A or B:
• Mode A: Press "Auto" buttón, automatic mode A start to work (the indicator
Light on the Left is on), the indicator lights of kneading function anda ir
massage function are on, the below functions will work:
1. Combination air pressure massage with kneading function
2. Air pressure massage function
3. Kenading massage function
The above three kinds of function in cycle to the auto shut off time of 15
minutes to end.
• Mode B: Press "Auto" button again, automatic mode B start to work (the
indicator Light on the right is on), the below functions will work:
1. Air pressure massage mode
2. Kneading massage mode
3. Combination air massage mode with kneading massage mode.
The above three kinds of function in cycle to the auto shut off time of 15
minures to end.
Press "Auto" button again, automatic working mode is off. Manual working
mode Works. This massager has the function of "15 minutes auto shut off",
when the massage time is reach to 15 mins, it stops working.
OPERATION INSTRUCTION
23