Zenoah GZ3500T Manuel D'utilisation page 16

4. Set the choke control in the choke position.
To prepare start with a warm engine
1. Move the front hand guard forward to engage the
chain brake.
WARNING: The chain brake must be
engaged when the chainsaw is started to
decrease the risk that the saw chain
touches you during start.
2. Press the air purge again and again until fuel starts
to fill the buld. The bulb does not need to be
completely filled up.
3. Set the start/stop switch to the start position.
16
Note: Do not set the choke control in the choke position.
To start the product
1. Hold the front handle with your left hand and press
the product against the ground.
WARNING: Make sure you have safe
stands and that the saw chain cannot
touch anything.
2. Pull the starter handle with your right hand and pull
out the starter cord slowly until you feel a resistance
(as the starter pawls engage). Pull the starter cord
firm and quickly until the engine starts.
WARNING: Do not twist the starter cord
around your hand.
CAUTION: Do not pull the starter cord to
full extension and do not let go of the
starter handle when the starter cord is
fully extended. This can cause damage
the product.
3. Push down the choke control as soon as the engine
fires, which can be heard through a "puff" sound.
4. Pull the cord powerfully until the engine starts.
5. Apply full throttle as soon as possible when the
engine starts. The throttle start lock will disengage
automatically.
308 - 004 - 27.09.2017