Troubleshooting Guide - Daga E Mode D'emploi

SAFETY AUTOSTOP TIMES, OPERATION TIMES
AND COMFORT PROGRAM PER MODEL
Models
E, E2, EP,E2P

TROUBLESHOOTING GUIDE

PROBLEM
The controller does not
turn on when I move
the side On/Off switch.
The heating pad
doesn't warm up.
After turning it on, the
control panel does
not configure the Free
mode, heat setting 1,
and the heating pad
does not heat up.
TÉ R MICAS2-ALL.indb 15
Tempera-
Available
ture
operation
Decrease
times (min)
(min)
--- 90
SOLUTION
Make sure the power supply is
working and that the heating
pad is correctly plugged in.
For heating pads with incorporated
adaptors, also check the
connection between the adaptor
and the heating pad.
Also, make sure that the side On/
Off switch is in the "I" position.
The preselected operation time stop or
safety Autostop could have activated
itself. Verify that the heating pad
is working by checking that some
of the red lights are turned on. In
case of doubt, press any of the keys
to return to the Free mode or turn
the heating pad off and on again.
The controller could have found
an anomaly in the start-up
and blocked the heating pad's
operation for safety purposes.
Turn the controller off and on again. If
this incidence persists, please contact
our authorized technical service center.
Comfort program
Number Time per
Safety
of phase
Autostop
phases (min)
8h --- ---
Tempera-
Program
tures
total
sequence
time (h)
(setting)
--- ---
15
15/03/10 16:17