Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connect Vent
1. Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4" (102 mm) clamp.
2. Using two or more people, move dryer to desired installation
location. Do not crush or kink vent. Make sure dryer is level.
Complete Installation
1. With dryer in final position, place level on top of the dryer, first
side to side; then front to back. If the dryer is not level, adjust
the legs of the dryer up or down until the dryer is level.
2. Using a TORX
T20 security driver, open the control panel
®†
and rest it on the bottom edge of the opening.
REVERSING THE DOOR SWING (OPTIONAL)
You can change your door swing from a right-side opening to a
left-side opening, if desired.
B
1. Open dryer door. Remove bottom screws from cabinet side
of hinges (A). Loosen (do not remove) top screws from
cabinet side of hinges.
2. Lift door until top screws in cabinet are in large part of
hinge slot. Pull door forward off screws. Remove top
screws from cabinet.
3. Remove screws attaching hinges to door.
4. Remove screws from all sides of door (5 screws). Grasp sides
of outer door and gently lift to separate it from inner door (do
not pry apart). Do not pull on door seal or plastic door catch.
3. For added security between the upper dryer and the collar,
insert the cotter pin through the connecting bolt.
4. Close the control panel.
5. Plug in dryer or reconnect power.
6 Check dryer operation.
Select a full heat cycle, let the dryer run for at least five
minutes. Dryer will stop when time is used up.
NOTE: Dryer door must be closed for dryer to operate. When
door is opened, dryer stops, but time continues to count
down. To restart dryer, close door and reselect cycle.
7. Now start the dryer and allow it to complete a full heat cycle
to make sure it is working properly.
5. Reattach outer door panel to
inner door panel so handle
is on the side where hinges
were just removed.
C
6. Attach door hinges to dryer door so that the larger hole is
at the bottom of the hinge and the hinge pin is toward the
door front.
A
7. Remove the 4 screws that attach 2 plugs (B) on the handle
side. Attach plugs to opposite side using the same 4 screws.
8. Insert screws into bottom holes on left
side of cabinet. Tighten screws halfway.
Position door so large end of door hinge
slot is over screws. Slide door up so
screws are in bottom of slots. Tighten
screws. Insert and tighten top
screws in hinges.
9. Close door and check that door strike aligns with door
catch (C).
† ® TORX is a registered trademark of Saturn Fasteners, Inc.
15
15
Publicité
Table des Matières
