Dennerle Scaper's Flow Mode D'emploi page 8

Aquascaping
Scaper's Flow
Hang-on external filter for aquascaping aquariums, 30 – 120 l
- Please read all instructions carefully before turning the equipment on. Save these instructions for future reference. -
Congratulations on purchasing this high-end Dennerle product. We wish you years of enjoyment and pleasure with your aquarium!
1 Security notes
• For use with 230 V/50 Hz alternating current only.
• For indoor use only.
• Always disconnect all equipment in the water from the power supply before reaching into the aquarium.
• The mains plug must be permanently accessible once the device is in place.
• All cables leading from the aquarium, including the power cables for the equipment, must have a drip loop attached so that any
water running down cannot reach the equipment and/or the mains outlet.
• The equipment must not be used if the power cord is damaged. Damaged power cords must not be replaced.
• This equipment is not intended to be used by persons (including children) with limited physical, sensory, or mental capacity, lack of
experience, and/or lack of knowledge, unless said persons are supervised for their own safety by another responsible person or are given
instructions by this person on how to use the equipment. Children must be supervised to ensure that they do not play with the equipment.
• Magnetic fields can cause electronic or mechanical defects and damage to the equipment. This also applies to cardiac pacemakers. For
information about the requisite safe distances, please refer to the instruction manual for your medical device.
• To be used for the specified purpose only. The use of any additional parts not recommended by the equipment manufacturer can result in
unstable operation, for which the manufacturer offers no warranty.
• Permitted water and room temperature range: 10 - 35 °C
• Maximum pump head: 60 cm. Please position filters accordingly.
• Please install the entire filter before switching on. Fill the filtration chamber with water before switching on to ensure that the pump can
function correctly.
• Do not use the filter if the filter head gets hot or makes unusual noises.
• When you install the filter for the first time, leave it to run for 24 hours in a water circuit (e.g., a separate aquarium or bucket) before adding fish,
to remove any residues potentially left over from the production process.


24
25
8
2 Component names and components included
No. Name
23
1 Filter bowl
2 Filter head with pump and seal
3 Stoppers with seal for water filler opening
4 Power cord
22
5 Suction pipe, split
6 Suction pipe, extension
21
7 Intake protection (filter sponge)
8 Corner piece with 2 O-rings
20 9 Corner piece, elastic, 55 x 30 mm
10 Screwcap
11 Tube connector
12 Corner piece, elastic, 22 x 30 mm
13 Lily pipe
14 Filter holder
15 Pipe holder, left
16 Pipe holder, right
17 Cover plate for filter holder
18 Spacer incl. rubber
19 Filter basket
20 Pre-filter sponge
21 Fine filter pad filled with active charcoal
22 Bio filter tubes
23 Cover for filter basket
24 90° tube guide
25 Tube holder (for 5mm thick glass)
Filter
Add-on components
Filter basket and filter materials 
Accessories for running a standing filter,
with 12/16 mm tubes (not included) 
t
Total number
1
1
1
1
1
1
1
2
2
6
1
1
1
2
1
1
2
1
2
1
1
1
1
2
2