Oceanic OCEAISHGB1000W Guide D'utilisation page 22

 If the power cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
 The appliance should not be placed immediately
below a socket.
WARNINGS

overheating, do not cover the heater.
 Do not use this heater with a programmer, timer,
separate remote control system or any other
device that turns on the heater automatically
because there is a risk of fire if the device is
covered or placed incorrectly. Use only a remote
control device connected by the pilot cable.
 The device must be powered by a Residual
Current Device (RCD) with a rated operating
differential current of not more than 30 mA.
 Warning: if this appliance is installed in a
bathroom, it must be installed at least 60 cm
from a bath or shower (volume 2), in accordance
with the requirements of the French electrical
installation standard NFC 15 -100.
 The device must be connected to a circuit
independent electric protected by a bipolar
circuit breaker according to the standard
electrical installation NF C 15-100.
 WARNING: The heater must not be used if the
glass panels are damaged.
 With respect to the details of how to install the
appliance
"INSTALLATION" section.
onto the
Page 22 of 38
： In order
wall,
to
refer to
avoid
the