Operation; Other Symbols In This Documentation; Units Of Measurement; Safety - Stiebel Eltron FEK 2 Utilisation Et Installation

OPERATION

Safety

1.3 Other symbols in this documentation

Note
general information is identified by the adjacent sym-
bol.
f Read these texts carefully. f
Symbol Meaning
Material losses
(appliance damage, consequential losses and environ-
mental pollution)
Appliance disposal
f This symbol indicates that you have to do something. The
f
action you need to take is described step by step.
These symbols show you the software menu level
… …
(in this example level 3).

1.4 Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
2. Safety
2.1

Intended use

The appliance is intended for domestic use. It can be used safe-
ly by untrained persons. The appliance can also be used in
non-domestic environments, e.g. in small businesses, as long
as it is used in the same way.
Any other use beyond that described shall be deemed inappro-
priate. Observation of these instructions and of the instructions
for any accessories used is also part of the correct use of this
appliance.

2.2 General safety instructions

WARNING Injury
The appliance may be used by children over 8 years
of age and persons with reduced physical, sensory
or mental capabilities or a lack of experience and
expertise, provided that they are supervised or they
have been instructed on how to use the appliance
safely and have understood the potential risks. Chil-
dren must never play with the appliance. Children
must never clean the appliance or perform user
maintenance unless they are supervised.

2.3 Test symbols

See type plate on the appliance.
FEK 2

3. Appliance description

The digital remote control enables one heating zone to be con-
trolled. The appliance measures relative humidity and room
temperature. The use of room temperatures as measured by
the appliance improves the quality of control provided by the
heat pump manager.
The appliance is compatible with the following heat pump
managers:
- WPM (1st generation)
- WPM II, WPM 2.1
- WPM 3 (i)
4. Operation
4.1

Controls

4
3
MENU
1 "OK" sensor button
2 Touch-Wheel
Note
If you have gloves on, have wet hands or the program-
ming unit is damp, this impedes the recognition of
your touch and the execution of the action you re-
quire.
Note
If a button is touched for too long, the appliance does
not respond.
f Tap the sensor buttons only briefly to initiate the
f
required action.
Control Function
Touch-Wheel Make settings, select menu item
"MENu" sensor but- Scroll left, go back one menu level
ton
"OK" sensor button Scroll right, open menu item, save
settings
1
OK
2
3 "MENu" sensor button
4 display
| 11