Xplova NOZA ONE Guide De Démarrage Rapide page 7

3. Put the front leg on the ground as a
support to lift the trainer, put rear bottom
tube bolt through the holes on the rear
bottom tube and secure it tightly to the
trainer main unit. Then use the rear bottom
wrench to screw the rear bottom tube nut
tight, and then install the decorative bolt
cover.
4. Tighten the bolts in the direction according
to illustration, screw tight the front bottom
tube. (Bolt and nut are included in the front
bottom tube)
5. After removing the filler from the flywheel/cassette cover, place the flywheel/
cassette cover in the direction shown in the figure below and tighten it, use the
flywheel/cassette cover wrench to tighten the two flywheel/cassette cover bolts.
6. Install the battery according to the
following diagram:
6.1. Take out the control module from the
accessory bag and put in two AAA batteries.
6.2. Put the control module into the main
beam according to the direction shown in the
figure.
6.3. Use a screwdriver to tighten the control
module screws to complete the battery
installation.
EN-5
Assembly Instructions