Electrolux WA51-303 Série Mode D'emploi page 3

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 68
CAUTION! – WALL MOUNTING: AVOID INJURY OR DAMAGE TO PROPERTY
Always use appropriate screw and plastic plug for wall hang hook, depending on the
wall material (e.g. nailable plug with screws for concrete OR expandable plug with
screws for drywall, etc.). If you are not sure of the type of wall, have a qualified
builder OR constructor inspect and recommend the correct screw and plug type
according to local or national building standards.
Do not, under any circumstances, use the wall hang hook with only one screw.
Always use appropriate safety precautions and protective gear while drilling holes
into the wall OR handling such equipment (e.g. safety gloves, dust mask, etc.).
Do not pull on OR tug on the unit from the power cord while it is wall mounted. Please
ensure power cord is snug to the wall and the floor to avoid any undue tangling of
objects with the cord and thus accidental tugs to the unit.
Ensure the wall hang hook is secured to the wall firmly and at the correct angle (e.g.
parallel to the floor without any leaning) for best results.
If unsure of whether the wall hang hook has been secured correctly on the wall,
before mounting the unit, please test the hook by a) applying some pressure on it
from the top with your hands to see if it buckles and b) tugging the hook towards you
with some pulling motion to see if screws come loose.
INFORMATION ABOUT RADIO
WiFi working frequency and maximum output power: 2.4 GHz; 15dBm
RFID working frequency and maximum output power: 13.56 MHz; 30dBm ± 10%
Power consumption of the product in network standby is less than 2.0W
ELECTRICAL SAFETY INFORMATION
WARNING! – AVOID FIRE HAZARD OR ELECTRIC SHOCK
This unit can be used in 50Hz or 60Hz power supply without any change.
Do not use an extension cord or an adaptor plug.
Do not remove any prong from the power cord. Do not pinch, bend, or knot the
power cord.
Do not cut or damage the power cord. If the supplied power cord is damaged, it
should only be replaced by Electrolux, its service agent or similarly qualified persons.
This unit contains no user serviceable parts. Always call an authorized Electrolux
servicer for repairs.
Do not, under any circumstances, cut, remove or bypass the grounding prong (see
picture 26 on page 3; for UK see picture 27). If you are not sure the outlet is
adequately grounded or protected by a time delay fuse or circuit breaker, have a
qualified electrician install the proper outlet according to the National Electrical Code
3
www.electrolux.com

Publicité

Table des Matières
loading

Table des Matières