Location And Function Of Parts - Sony BC-U2 Manuel D'installation

Location and Function of
Parts
a DC OUT connector
Supplies DC power to a connected device via the supplied DC output
cable when the mode select switch is set to DC OUT.
The DC output cable has a plug with black insulation and a plug with
yellow insulation. Connect the plug with black insulation to this
apparatus and the plug with yellow insulation to the connected
device.
Notes
• Do not connect a device with power requirements higher than the
specified values.
16

Location and Function of Parts

• Depending on the power consumed by the connected device, the
apparatus may become warm. This is not a malfunction. Avoid
prolonged contact with the apparatus if it should become warm.
b Channel 1 charge connectors
Supplies power when the mode select switch is set to CHARGE.
The charging current is automatically blocked when a battery pack
other than a lithium-ion battery pack has been mistakenly attached.
c Channel 2 charge connectors
Supplies power regardless of the setting of the mode select switch.
The charging current is automatically blocked when a battery pack
other than a lithium-ion battery pack has been mistakenly attached.
d AC input connector
Connects to an AC power source via the AC power cord.
e CHARGE indicators
Shows the charging status of the attached battery packs during
charging of battery packs.
For details, see "Charging Battery Packs" on page 17.
f Mode select switch
CHARGE: Supplies power to lithium-ion battery packs connected
to channel 1 and channel 2.
DC OUT: Supplies DC power from the DC OUT connector, and at
the same time supplies power to a lithium-ion battery pack
connected to channel 2. (A battery pack connected to channel 1
is not charged.)
g DC OUT indicator
Lights in green when the mode select switch is set to DC OUT and
DC power is being supplied.
If some trouble is detected, the indicator goes dark.