Secondary Parameters - Ugin ARTIS NEO Mode D'emploi

Instructions for use (rev 290319) ARTIS NEO

7. SECONDARY PARAMETERS

This is a second series of parameters that can be modified. These parameters correspond to the
appliance's technical data, but only some of them affect the firing functions.
To access the latter when the furnace is on "STAND-BY" or "IDLE" position: press both the and
keys at the same time.
 Page 1
 Page 2
PENTE V: temperature rise speed from standby mode to preheating mode (20 to 200°C/min)
 Page 3
 Page 4
UGIN DENTAIRE 31