Safety Instructions; Starting Procedure; To Attach Spent Mandrel Container - Gesipa PowerBird Pro Mode D'emploi

Masquer les pouces Voir aussi pour PowerBird Pro:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
GB
2.5

Safety instructions

Caution:
The following safety rules must be observed for adequate protection against electric
shocks, injuries or fire hazards:
The blind riveting tool should be used exclusively to set blind rivets!
Do not overload the tool; work within the prescribed work capacity.
Never use the blind riveting tool in a humid or wet environment or close to inflammable
substances or gases. Risk of explosion!
Ensure that the battery is properly secured in the grip.
Remove the battery when the blind riveting tool is not in use and for repair/servicing
operations.
The battery may only be charged in the temperature range between 0 °C and +55 °C.
Do not use the blind riveting tool as a hammer.
The blind riveting tool should be stored frost-proof and dry, in a locked room and out of
reach of children.
When working with the tool, always wear protective goggles. Personal protection like
clothes, gloves, safety helmet, non-slip shoes, ear protection and anti-fall protection are
highly recommended.
The air inlets for the motor should not be obstructed. Do not introduce anything into them.
When setting the blind riveting tool down, make sure that it cannot fall.
Use only genuine spare parts for repair.
Repair work must be carried out by skilled workers. In case of doubt, always send the
blind riveting tool back to the manufacturer.
Do not use the tool outside of riveting holes! The blind rivet could be ejected from the
tool! Never turn the tool towards yourself or towards another person!
The mandrel container (H) must be mounted on the blind riveting tool tool during opera-
tion.
2.6

Starting procedure

Insert fully charged battery in correct position into housing.
Select correct nosepiece according to table 2.4.
To screw in the nosepiece, activate the switch and proceed until the stop position has
been reached at the back.
Then remove the battery. Screw in the nosepiece and tighten it using the wrench
provided. Put the battery back in and activate the switch.

2.6.1 To attach spent mandrel container

Fully screw on spent mandrel container by turning clockwise.
18

Publicité

Table des Matières
loading

Table des Matières