Panasonic TY-WK85PV12 Manuel D'installation page 13

Precautions with regard to setting up
WARNING
Ensure that the installation location is strong enough to support long-term use.
• If its strength becomes insufficient over the course of long-term use, the display may drop, possibly causing injury.
Installation and removal should only be carried out by a qualified technician.
• If the bracket is installed incorrectly, the display may fall down and personal injury may result.
Make sure that all safety factors regarding strength of installation are observed.
• If the installation strength is insufficient, the display may fall down and personal injury may result.
Do not install in places which are unable to bear loads.
• If the strength of the installation surface is insufficient, the display may fall down and personal injury may result.
Do not disassemble or remodel the wall-hanging bracket.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
CAUTION
Do not install in places which are subject to humidity, dust, oil fumes, water vapour or excessive heat.
• These can have adverse effects on Plasma Display operation, and fire or electric shocks may result.
Do not use any displays other than those given in the catalogue.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
Do not install the Plasma Display face up, sideways or upside down.
• Doing so may cause heat to build up inside the display, and fire may result.
Do not hang from the plasma display or wall-hanging bracket or hang any objects on either the
plasma display or the wall-hanging bracket.
• The plasma display may fall over, possibly causing injury.
When installing or removing the plasma display, use a lowering device (machine), and ensure that
the work is done by at least four persons.
• If four people are not present, the display may be dropped, and personal injury may result.
Do not block the ventilation holes. When using the wall-hanging bracket, do not block the space
between the rear surface of the plasma display and the wall surface.
• Otherwise heat may build up inside and cause a fire.
Secure at least 10 cm (3.9 inches) of space at the top, bottom, left and right of the plasma display.
Also secure at least 15 cm (5.9 inches) of space at the back.
• Failing to do so may result in a fire.
When assembling and installing the wall-hanging bracket, make sure that the screws in all the
locations are tightened up securely.
• Failure to do so may result in warping, deformation, or degradation of materials, and a loss of strength
that may cause the equipment to fall over or break and cause injury.
Dispose of the product when it is no longer going to be used.
• Otherwise, it may break and fall down, possibly causing injury.
Requests regarding handling
1) Exercise care when selecting the location for the display because it may discolor or deform due to
light or heat if it is placed where it is exposed to direct sunlight, or near a heater.
2) For cleaning, wipe the display using a soft dry cloth (made of cotton or flannel). If the unit is
extremely soiled, first wipe off soiling with a neutral detergent diluted in water, and then wipe with
a dry cloth. Do not use cleaners such as benzene, thinner or furniture wax because they may
cause paint peeling. (For information on cleaning the display unit, see the display unit's instruction
manual. If using a chemicallytreated cloth, follow the instructions supplied with the cloth.)
3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the wall-
hanging bracket. Do not allow long-term contact with rubber, vinyl products or the like. (Doing so
will cause deterioration.)
4) The panel of the plasma display is made of glass. Do not apply a strong force to it or subject it to impact.
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING
DEATH RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
13