General Guidelines; Preparation - Toolland AC06 Mode D'emploi

3.

General Guidelines

•
Refer to the Velleman
manual.
•
Protect this device from shocks and abuse. Avoid brute force when operating the
device. Protect the device against extreme heat, dust and moisture.
•
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
•
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
•
Keep this manual for future reference.
4. Features
•
overload protection (for charger)
•
for various motor cars, vans and light trucks
•
included accessories:
5. Overview
Refer to the illustrations on page 2 of this manual.
A
B
6.

Preparation

Always check the condition of the cables and clamps before using the battery charger.
•
Disconnect the battery from the vehicle before charging. To do this, first remove
the negative pole connection, and then proceed with the positive pole connection.
•
When applicable (non-sealed battery), check the level of the battery acid. When
necessary, add distilled water.
V. 06 – 03/12/2020
®
charging cable (1.5 m + 1.5 m)
o
two clamps
o
2 replaceable spare fuses
o
red LED
yellow LED
Do not use when damage is noticed!
AC06
Service and Quality Warranty on the last pages of this
REMARK
6
green LED
C
fuse with indicator (20 A)
D
©Velleman nv