IDEAL AP60 PRO Mode D'emploi page 39

Troubleshooting
The indicators on the control panel do not
light up at all.
Automatic mode is not working properly.
Odours are not being filtered properly.
Is the air purifier switched on?
 Switch the air purifier on by pressing the
on/off button (A, page 30).
Has the Quiet function been activated?
 Disable the Quiet function by pressing
the Quiet button (D, page 32).
The air purifier calibrates the air
quality sensor. This happens when you
first switch it on and after disconnecting it
from the mains.
 Wait until the calibration process
(see Note, page 30) has been completed
(this may take a few minutes)
The air quality sensor is dirty.
 Clean the openings for the air quality
sensor (L, page 30), the air intake ducts
(page 29) and the interior of the air purifier
(where the filter cartridge is located) with
a vacuum cleaner.
The air quality sensor is not detecting the
air quality reliably
 Calibrate the air quality sensor by briefly
disconnecting it from the mains again!
Is the activated carbon in the filter
cartridge spent?
 Replace the filter cartridge (page 36).
If the air purifier has been continuously
exposed to strong odours, it may be that
the activated carbon is spent before the
filter replacement indicator (F, page 32)
lights up.
Are the odours being drawn in at all?
 Place the air purifier closer to the source
of the odours.
 Switch the air purifier manually to a higher
fan speed (page 31).
39