Carmen NT1650 Mode D'emploi page 5

Eyebrow trimmer attachment
Place the eyebrow trimmer attachment onto the appliance as
described. Place the eyebrow trimmer close to the skin and
carefully move across the excess hair. In order to prevent
unpleasant results, do not remove too much hair at once.
Handle the eyebrow trimmer attachment with care. Before
trimming, clean the respective areas of skin.
Eyebrow trimmer attachment with comb attachment
Choose one of the comb attachments (3-5 mm or 6-8 mm)
and push it over the eyebrow trimmer attachment so that it
locks in place with an audible click. The comb attachment's
tooth should point in the same direction as the cutting
unit. When placing the comb attachment onto the eyebrow
trimmer attachment. Place the comb attachment to the
eyebrows and start the appliance. Trim against direction of
the hair growth.
Trimming Nose/Ear hair
• Make sure nasal passages are clean.
• Place nose/ear trimmer on the body
• Switch the trimmer on and insert the tip of the
attachment into one nostril.
• Slowly move the tip in and out while turning it around at
the same time in order to remove unwanted hair.
For best results, make sure the side of the tip is firm
against skin. This will reduce the tickling effect that can
occur during trimming of nose hair.
• Turn off trimmer. Wipe attachment clean after each use.
> CLEANING AND MAINTRANCE
• Use the enclosed brush to remove hair and/or rinse the
cutting head under running warm water.
• Always remove the comb (if used) and wash it separately.
• Do not immerse the complete appliance in water.
• Wipe dry with a towel before you put on the protection
cap.
ENGLISH • 5