Hilti DD100 Mode D'emploi page 5

DD100 basic unit
➂
➄
➀
➁
Electronic switch (easy hole-starting)
➁
Side handle
➂
Depth gauge ( not fitted)
➃
Overload indicator
➄
Speed-change switch
Symbols
Read the operating Return waste material
instructions before use. for recycling.
Do not use this product in any way other than as directed by these operating instruc-
tions.
Before beginning work: Please observe the enclosed safety precautions!
Please keep these operating instructions in a safe place.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069507 / 000 / 00
➀
➃
When working with the machine, it must be held with two hands.
Always make sure that you have a safe stance/ foothold.
Technical data
Weight
as per EPTA-Procedure 01/2003:
Dimensions:
Drill bit size range: dry
wet
Chuck for core bits:
Chuck for dry-cutting core bits:
NOTE
The vibration emission level given in this information sheet has been measured in
accordance with a standardised test given in EN 60745 and may be used to compare
one tool with another. It may be used for a preliminary assessment of exposure. The
declared vibration emission level represents the main applications of the tool. However
if the tool is used for different applications, with different accessories or poorly main-
tained, the vibration emission may differ. This may significantly increase the exposure
level over the total working period. An estimation of the level of exposure to vibration
should also take into account the times when the tool is switched off or when it is run-
ning but not actually doing the job. This may significantly reduce the exposure level
over the total working period. Identify additional safety measures to protect the oper-
ator from the effects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Noise and vibration information (measured in accordance with EN 60745):
Typically the A-weighted noise levels of the tool are:
– sound pressure level:
– sound power level:
For the given sound power level as per EN 60745, the tolerance is 3 dB.
Wear ear protection.
Triaxial vibration value (vibration vector sum)
measured in accordance with EN 60745-2-1
Drilling into sand-lime-stone, dry, (a
Uncertainty (K) for triaxial vibration value :
Right of technical modifications reserved!
6,4 kg
Approx. 440×115×155 mm
∅ 16–162 mm dia.
∅ 8– 42 mm dia. (hand held)
∅ 8– 87 mm dia. (drilling rig)
Hilti quick-change DD-BI
Key-type chuck
89 dB (A)
100 dB (A)
): 10.5 m/s 2
h, DD
2.3 m/s 2
5