Miele STB 201 Mode D'emploi page 12

en - Cleaning and care
,
Always disconnect the vacuum
cleaner from the electrical supply for
cleaning or maintenance work on
the Turbobrush. Switch off at the
wall socket and remove the plug.
Removing threads and hairs
^ Cut any threads or hairs that have
become entangled on the roller brush
with a pair of scissors. Then run the
vacuum cleaner to vacuum up the
bits.
For more obstinate tangles or blocka-
ges inside the Turborbrush, the cover
can be opened. Any large particles in-
side it can then be easily removed.
^ Loosen the two locking screws on the
underside of the brush with a coin,
and take off the roller cover.
^ Remove any dirt in the brush
compartment interior and from the
roller brush.
^ Put the roller cover back on and
close it.
^ Tighten the locking screws.
12