Enter User Information - Multiplex POWER PEAK TWIN EQ-BID 1000W Notice D'utilisation

5.6 ENTER USER INFORMATION

Th t bl The table summarises all the of the Parameters that may be used. i
Parameter
Temperature units
Button beep
Finish melody
Melody
Operating Instructions
Power Peak ® Twin EQ-BID
Use the "MODE-/ESC" buttons to set-up the User
Settings in the main menu.
Activating the "TEMP MODE" line in this main menu, one
can set-up the desired temperature units. There is the
choice of ° C and ° F to select from.
The second line "BUTTON SOUND" can be pre-set,
whether every press of a button sounds or not. There are
two possibilities, the sound can be turned on- or off.
By activating the third line "FINISH SOUND", the time it
plays can be set. There are the following options:
Off - 5 secs. - 15 secs. - 1 Min. - On
In the "MELODY" line, one can select from 10 diffe-
rent melodies to play at the end of a charge procedure.
Following the selection of a new melody, this will be played
until the "ENTER" button has been pressed.
ll th
Settings
F / C
O O
ON/OFF
Off - 5 secs. - 15 secs. - 1 Min. - On
Sounds 1 to 10
17
51
# 30 8563